The Ardara Technologies Optics Power Supply was designed to provide stable high voltages suitable for up to eight optics elements, including lenses, ion guide offset potentials, pre-filter offset potentials and other ion optics devices.

• Eight +/-400 volt outputs standard.
  •  Individual outputs can be factory configured for +/-50V, +/-100V or +/-200 V
  • 2 MOhm output impedance.
• Features front panel ten-turn potentiometers for fine control of each output.
• Front panel display select switch allows direct measurement of each individual output voltage using front panel digital voltmeter.
•  Back panel DB25 connector features external command input for each of the eight outputs.
  • +/-5.0V command yields +/-400 V output, 1 MOhm input impedance.
  •  Unit automatically switches between front panel control and external command if pins 24 and pins 25 of the external connector are shorted.
• External Master Command offers the control of any or all of the optics voltages to float off of a Master. 
  • Master Command can be chosen either externally or one of the 8 Optics outputs can serve as the Master Command.
  • Slave outputs can be selected by the addition of a jumper wire on the internal optics board. 
  • Any output can be turned into a slave or can be left independent.
  • This is enables downstream voltages to float off the Master, automatically being adjusted by changes made upstream.
  • The Master Command can also be outputted to other electronics form the Optics Power Supply.
• Supported by a wide range of cable options. 
• Dimensions:  19 inch rack mount front panel, 3.5 inches tall, 15 inches deep.
• Universal AC input (100-240VAC, 50-60 Hz)