PS 6501A Optics Power Supply

The Ardara Technologies Optics Power Supply was designed to provide stable high voltages suitable for up to eight optics elements, including lenses, ion guide offset potentials, pre-filter offset potentials and other ion optics devices.

• Eight +/-400 volt outputs standard.
  •  Individual outputs can be factory configured for +/-50V, +/-100V or +/-200 V
  • 2 MOhm output impedance.
• Features front panel ten-turn potentiometers for fine control of each output.
• Front panel display select switch allows direct measurement of each individual output voltage using front panel digital voltmeter.
•  Back panel DB25 connector features external command input for each of the eight outputs.
  • +/-5.0V command yields +/-400 V output, 1 MOhm input impedance.
  •  Unit automatically switches between front panel control and external command if pins 24 and pins 25 of the external connector are shorted.
• External Master Command offers the control of any or all of the optics voltages to float off of a Master. 
  • Master Command can be chosen either externally or one of the 8 Optics outputs can serve as the Master Command.
  • Slave outputs can be selected by the addition of a jumper wire on the internal optics board. 
  • Any output can be turned into a slave or can be left independent.
  • This is enables downstream voltages to float off the Master, automatically being adjusted by changes made upstream.
  • The Master Command can also be outputted to other electronics form the Optics Power Supply.
• Supported by a wide range of cable options. 
• Dimensions:  19 inch rack mount front panel, 3.5 inches tall, 15 inches deep.
• Universal AC input (100-240VAC, 50-60 Hz)